How to calibrate the milling cutter, milling cutter and cutter blade?
1. disc mill, we call him face milling cutter.2., the opposite side of the milling cutter for correction, there are generally several testing methods:(1) on the machine blade, directly on the machine tool, machine tool used in the table, or the appropriate position, absorb a dial gauge, head to the flat table. The radial and axial runout of the blade edge were detected respectively. This method is used more in some small businesses.(2) of 1 in the cutting machine, machine tool on the radial and axial of edge detection at the same time. This is the method used in most mechanical processing plants.(3) 2 of the cutting machine, in the tool room specially prepared by a marble slab, with clip with a dial gauge bracket, or a table frame clip one thousand table to check the radial and axial runout. This is used in some large mechanical processing plants.3. sides milling cutter, organic clamp, no heavy grinding blade and two welding knives. There are two major categories of accommodation and non adjustment.
Find a pane of glass and lay it flat on the bed. Release all the ends of the knife on the glass plate. It is easy to find the plane.
The milling cutter is usually equipped with several knives, which are adjusted to high and low angles, near and far wrong positions. In milling, several knives are layered to reduce the cutting force of each knife. In the calibration of the knife, the knife can be carried out from the shortest installation, first shake to close the knife milling machine, the first knife is fixed, then the milling machine reduces a distance, and then install the second knife. Then reduce the milling machine to the same distance, and then install third knives,...... And so on, until all the knives have been installed. When installed, each knife should be next to the milling machine table or other reference, this installation position of each knife is the same, in the milling, each knife cutting depth will be as much.
