Home > categories > Security & Protection > Lightning Rod > how to change heater hose (connector that connects into heatercoil)?
Question:

how to change heater hose (connector that connects into heatercoil)?

When changing my heater hose(lower radiator hose) i noticed that the connector type fitting that sticks out of the firewall of my car is cracked in half and that was were it was leaking. how do i change that piece. i tried unscrewing it but that didnt work. i tried giong thru the dashboard floor area and only get stuck with things that i can't remove. i can not put the hose back on until i have the small piece replaced. someone said it is connected into the heater coil? behind the fire wall?

Answer:

Time Note in the video the initial strike and how the lightning brightens and dims several times. Each pulse is often referred to as a strike, though really the whole instance is really one strike.
Two things could be a factor, the location of your alarm and the amount of rum you apply to the food. In theory there shouldn’t be too much smoke to set off the alarm. I use a ladle and set fire to the liquid first then poor it over the food. If you have been watching cookery programmes where this is done remember they have high ceilings and use a lot more to show the effect. Always keep a fire blanket at hand just in case.

Share to: