How to connect the carbon brush and the power supply of the 2 coil of the stator coil of the electric drill?
One end of a stator winding is connected with a carbon brush, and the tail end of the stator winding is connected with a power supply; another stator winding is connected with a carbon brush at the end of the winding, and the end thread is connected with a power supply.After the line has been tested, if the reverse is needed, the ends of the two stator windings need to be interchanged.
Because the torch is a series of exciting motors, the stator and rotor are connected in series. The two stator windings are not directly connected.
The 2 wire of the stator coil of the electric hand drill needs one end to connect the power line, and one end is connected with carbon brush.
