How do I get the wire for the explosion proof lamp? Are there any special requirements? Are the wiring personnel qualified? Can the general electrician connect?Please answer, thank you!
What kind of explosion proof lamp, general explosion-proof lamp, general electrician can.
Explosion-proof lamp function: mainly for flammable, explosive and other dangerous goods storage, workplace installation. There is a glass shield and a protective net outside the bulb. It is not different from the ordinary lamp, so the professional electrician can install it.
Walk the line explosion-proof lamp taking the best galvanized pipe, because the line of explosion proof electrical equipment are generally required to walk, but not what connection request, now who is nothing to test that the qualification documents, but to find the best technical staff with explosion-proof equipment construction experience of wiring.
Electrician can also be operated, according to your product environment, can be directly from the lamp wiring down the best pipe routing channel outdoor long distance access line, such as a middle junction must use explosion-proof junction box, such as a control switch to use explosion-proof
Directly from the lamp wiring, it is best to use the pipe wiring channels, outdoor access to the main line longer distance, the middle if there is a line, it is necessary to use explosion-proof junction box, if there is a control switch, but also explosion-proof.Installation and connection of explosion proof lamp and its using methodExplosion proof lamp installation:1, determine the installation position of lamps and lanterns, choose the proper installation method, and according to the lamp to the 220V power supply contact distance, prepare the corresponding length of phi 6~8mm three core cable;Two 2, locking the socket open open the rear cover, three core cable will be ready to end through the inlet, the FireWire (L) connected to the "L" terminal, the zero line (N) connected to the N terminal on the ground (PE) connected to the PE terminal, then the cable into the mouth by pressing a nut tightly, close the rear lid lock buckle buckle, the three core cable the other end is connected with the power supply, lighting can be realized.3. When changing the bulb, use the method 2 to open the back cover, turn the lamp holder to the right, pull it out of the light cover, turn off the old bulb on the lamp holder and replace it with a new bulb.Be careful：1, transportation will be installed in the lamp equipped with cardboard box, explosion-proof lamp and add foam shock absorption.2, when used, the lamp surface has a certain temperature rise, is a normal phenomenon; transparent parts of the center temperature is higher, not touch.3, replace the bulb, should use the same type, power of the bulb; if change the bulb type or power, should replace the corresponding ballast.
