1, Firstly, you should clean up the dust and oil stain on the your hand by the hand sanitizer. 2, Use the glasses cloth or the soft cloth with no hair?slip dip in a small amount of water to wipe the surface of the phone, and the clean up the dust and fingerprints on the surface. 3, tear the one side of protective film, and then alige at the top and sides of mobile phone and paste the film. 4, When you paste the film, you should maintain constant speed, please pull back the film if there is bubble, in order that there is no bubble on the surface of film. Then use the wool or cushion scraper to avoid scratching. The film will be slowly pressed on the surface of the mobile phone, even if there are the bubbles, they will be less. 5, After finish the pasting, you should treat the regional bubbles. Use the hard card and credit card which are wrapped by the screen soft to slowly scrap the bubbles out of the edge. 6, If there is a small dust particles on the surface, please disclose the whole film, stick up the particles by the adhesive tape, and then paste the film.
If there are bubble in the mobile phone film, please use hard bank card or other cards to gently squeeze out the bubbles from intermediate network edge and surroundding. The process should be slowly, you don't be impatient, and pay attention to not crumble the big bubble. You shouls spend a relatively long time to scrape the bubble to the edge, and then squeeze out the bubble. At last, mobile phone film is perfect and flawless. if there is dust in the mobile phone film, it is more difficult to solve than the bubbles, this film is possibly destroyed , because it represents that you live in a dirty environment, the suspended solids in the air are too much, where is not suitable for sticking film.
If the film is not pasted well, you can peel it off, and then rinse with the detergent and water. After that, you paste it with water again, holding a glasses cloth to squeeze out the water. If you failed to poste the film, you can still stick it again well.
