How to disassemble the figure
First put the tongue into the door side of the hole and a good screw on the plug, the key to the key from the door into the hole and plug the tongue with a good fit, and then remove the first disk on the inside of a good screw fixed, On the outer disk is good (usually on the outer disk as a car screw can be directly by hand can be tight), and then on the anti-lock the ball, anti-lock the ball is concave part of the more, and the door on the smaller parts of a position like Cut the place, anti-lock the ball concave into the site of the cut part of the cut to push, has been pushed in the end just right!
The ball lock in two, one plug the key, one is pressed down the lock button, in front of the anti-lock the ball to teach a small part of the small eyes, in the box with a component, and the screw is generally put together with the tip of iron Piece, with a pointed iron clip on the top of the eye with a flexible clip, the other hand can pull the anti-lock ball, and then unscrew the lock disk (an outer disk, an inner disc)
Whether the cylinder is a round or a general ball lock. If the ball lock is simple, and slowly turn the ball, when you see the ball near the end of the trails at the two holes aligned with the lock parts within the hole through the hole pressure inside the punch, press down after pulling the ball , Spin off the rear cover, through the door from the inside into the lock body, and then put the cover sheet,
