Home > categories > Automotive & Motorcycle > Car Alarms > How to I clear all transmitters on my car alarm system.?
Question:

How to I clear all transmitters on my car alarm system.?

if someone borrowed my car and installed their own. i have PTN on my alarm system which tells me the number of transmitters installed. i have two transmitters but it says there is three installed. the system can have up to four but i want only two. I have a CODE ALARM CA6553. the manual shows how to install but not how to delete or completely reset.

Answer:

cold air intake works but don't have it just sitting their on an engine block improvise get some hose from home depot have it drawn to the front of ur car u can set up a ram air system where it will get cold air forced in from outside cause its that cooler dense air u want be careful though allot of times itl upset ur air fuel mixture and set a check engine light but allot of times the computer will relearn and will correct itself after some time its up to you to think if its worth it u may see about a 5 to 10 horsepower increase
If you are looking for a cheap upgrade, you could do that, but I would also recommend getting a Tornado to go along with it. Another alternative that might be less expensive, would be a powerchip from Jet, or Hypertech. They usually run about $150-$200
why advertise such junk here? why not go to a car site? of course this doesn't actually work because if it did, the auto maker would supply it themselves.
Check their website. They often require a few steps. Like turning the car on then off then holding the remote pad after pressing this and or that etc etc. The steps have to be followed to the T though.

Share to: