1, Cleaning the ground and paving the extruded sheet of 2-3 cm thick. 2, Tailoring and laying the electrothermal film side by side according to the requirement. 3, Connecting the electric heating film parallelly (according to the standard construction connection drawings, single electrothermal membrane should not exceed 10 meters). 4, Using special tool to connect firmly the special clips with the electrothermal film metal loading bar and connecting the electric wire. 5, Wrapping connected parts with insulating plaster to prevent water and ensure insulation. 6, Allocating the air switch according to the total power, connecting the thermostat and sensor and putting the probe of the sensor probe into the area of the ground that is the easiest to be heated to prevent the heating film from being overheated. 7, adding the drive pipe to the sensor, cutting the drive pipe at the head of the sensor and sticking the sensor to the heated carbon strip of the electrothermal film with insulating plaster. 8, Checking it. 9, Wrapping the electrothermal?film with waterproof cloth (for cement construction) or paving non-woven fabric (for floor or the floor sheet construction). 10, Starting the temperature?controller to measure the temperature. 11, paving the geothermy plastic net, pouring cement mortar, inlaying floor tiles (cement construction) and paving the floor (floor construction) 12, The construction is completed.
It can be installed under the floor when decorating the house. It can begin to work when temperature?control is intalled by groups parallel connection method. Of course, it is quite simple when saying it. It is better to ask a professional company to install this kind of electric products for you. First, you can fix the baseboard and then put insulating layer with reflective film and electrothermal?film on it. In the final step, you can install some bamboo curtain splints or decorate fabric with good heat dissipation.
1 The most scientific way to install the electrothermal?film is to install it in the ground. In light of heat transfer theory, this is the best heating mode. From the perspective of health maintenance, the heat is flowing from the bottom to the top, which meets the physiological?needs that foot is warm and head is cool. Installing the electrothermal membrane in the ground can not only make people feel comfortable, and also can increase the usable floor area of space and guarantee the even temperature all over the area. However, because each family has different pattern and furniture is displayed differently, the limited space and degree of difficulty should be considered when designing the installation to ensure that there is no barrier in the installation process, make the electrothermal film heating system more safe and reasonable and reduce the cost of expenditure. Main structures are floorslab or floor, heat insulating layer, electrothermal?film, structure layer and the decorative layer. The composite thermal resistance of structure layer and the decorative layer should be lower than the standard value. 2 There are several ways to calculate the amout of the electrothermal?film for gound installation. 1 Calculating the thermal?load. You can first calculate the thermal power of each room and convert it into wattage of electrothermal film. Calculation of the heat load should be carried out by professionals. This method can be applied to large projects. 2 Empirical method. According to the conditions of the room, you can estimate the heat load of the room. This method is generally used for single family transformation project. 3. Fully paving method. When it is required that the whole area should be heated, the heat loading value can be ignored and areas which has human activities should be fully paved with the film. This method may increase the cost of pavement, but will not affect the operating cost.
