How to maintain the pile driver daily?
Daily maintenance of pile driver1 、 maintenance of each shift (after class, after class)(1) before the daily operation, the operator should clean the surface of the pile driver. Parts that need oiling must be lubricated 1-3 times a day to keep the lubricated parts lubricated. (2) remove dirt and dirt from the equipment. (3) check and fasten the connecting bolts of each department, check the lubrication and wear of main clutch, steering pump, fan bearing, high pressure oil pump, load wheel and idler pulley. If there are any problems, they should be dealt with in time.
(4) dealing with leakage and damage of hydraulic system in time. (5) count the tools and scrub them clean. Fill in the equipment operation record, and make the writing clear, neat, complete and accurate.First level maintenance: (120~150 hours per work) on the basis of the completion of the maintenance of the whole work of each class.
(1) engine parts: washable air filter, oil filter, diesel filter net. Release the fuel tank deposits and clean the fuel tank strainer. Check the main engine crankcase lubricating oil and clean the respirator. Check and adjust the tightness of generator belt and fan belt, and lubricate fan bearing. Check the water leakage of the pump and clean the oil outside the water tank. Check the flywheel connecting screws and connections with no breaks and replace them if necessary. (2) walk and control mechanism. Inspect the lubrication surfaces of each gear box and reducer. Add lubricating oil according to the standard level. Check the bearing wheel, idler pulley, driving wheel and axle bush, add enough lubricating oil and grease. The check and adjust the track tension, full track bolt tightening.
