Home > categories > Tools & Accessories > Knife > How to make the razor sharper and does no harm to the skin?
Question:

How to make the razor sharper and does no harm to the skin?

How to make the razor sharper and does no harm to the skin?

Answer:

The most common way to clean the head is to use clean water. When washing, the shaver body is best not to touch the water, so as to avoid mechanical trouble. If the product you are using is wet and dry, the base part will not be exposed to water, so as not to damage the motor.4, do not use an electric shaver that is not enough, and barely use it to damage the inside of the motor.5, razor used for a period of time, the knife head may breed mites. To this end, two weeks should be used in electric shavers, unscrew the knife head, pulled out the blade, swept away the stubble, then kill mites in cutter head drop half drops of essential balm, essential balm for special smell and the active ingredient is mite nemesis, and it does not make the blade rust oil, impact at the same time not on the skin. Be careful not to Fengyoujing dripping on the rotating shaft.
The electric shaver is widely welcomed by modern men because it adopts alloy mesh cover to avoid scratching the skin and prevent bacterial residue. But many men use electric shavers for a long time, but rarely clean them. In order to make it serve you longer, the maintenance of an electric razor is also important. In daily, should do the following maintenance: 1, often cleaning knife head, but in cleaning, pay special attention to don't let blade hurt. You can use the brush to remove the chip along the blade, and then spray clean disinfection lubricant, so that the blade to keep sharp. 2, knife head and skin close to achieve the best effect. When used, the razor and skin angle is best kept at ninety degrees, so that the cutter head can approach the beard unimpeded, so as to achieve the best shaving effect.
You can put some toothpaste on the net cover of the shaver and don't spread it too much, as long as it can be evenly covered on the net cover. When you're done, turn on the shaver, let it idle for two or three minutes, and then rinse off the toothpaste. The razor that handles it will be a lot sharper. This is because the special particles in toothpaste can sharpen the blade when the blade rotates. So, when your shaver is dull, just put some toothpaste on it. Electric shaver should also pay attention to maintenance

Share to: