How to remove and uninstall the installation of electric motor

Answer:

How to remove and uninstall the installation of electric motor:The disassembly is: there will be one side of the end cover screw brake unloading, good docking mark repaired after restoration in the end cover, the one side of the flywheel shaft nut, a piece of wood, hold the motor stator part, with shaft knock wood. After taking off, according to Holzer positive and negative control, replace Holzer (because of the angle must pay attention to), in accordance with the reverse step recovery. To be finished。

Hello, friend！ I'm in the car, I can tell you about the process of dismantling the motor: first with a trolley bracket hanging up tires from it, or the car upside down, (if you are chartered, that only with the former method.) Find the local controller, the connecting line controller and motor (three to unplug a motor plug line, Holzer line), the chain before and after that, the screw loose ends of the motor, the motor can take off. After the end of the line is loose motor with screw, hands holding force to knock the rim, (preferably mat of wood, to prevent the screw buckle worn). So knock out (the hand can extend into the slot) when two foot is on the rim, because inside the magnet magnetic motor, prevent the bumps, and then use the hand force to remove the rotor motor (the actual installation in the car after the stator) can see the inside of the structure. Installation time is relatively simple, in accordance with the demolition of the steps in turn can be, and pay attention to the point is that the rotor into the porcelain magnet when placed,

Because the magnetic is too big, so don't worry, to adjust the position, and then slowly move closer to the magnet (below, do not put in the hands of motor end cover to prevent crushing) then it is best not to feet, and after there is a certain gap, and then gently tapping with a hammer, or there is no gap to one can, can install screws, when screws are best for each relative to two or three at the same time strength, prevent both ends of the gap caused by the inconsistent motor will influent the remaining steps you can follow the disassembly process can be installed in the reverse order! Brushless motor, brush motor is the same as the steps above, the only difference is that the motor is connected to two lines. Hope to help you complete the disassembly and assembly of motor. (