Home > categories > Energy Products > Solar Vacuum Tube > How to remove the solar water heater tube
Question:

How to remove the solar water heater tube

How to remove the solar water heater tube

Answer:

The first time you remove the best choice is cloudy, morning or evening, because you must first put hot water in the solar water heater all let go before the demolition, demolition was oozing to avoid scalding hot water, if the demolition is at noon, because the vacuum pipe of the water has been drained, and then by the strong sunlight will loss and vacuum tube, vacuum tube will shorten the life of.3, after the demolition of vacuum tube to use special polyester foam grid installed, put in a special box, lest accident in handling collision. Because this step is the most difficult, the most dangerous for non professional people, a vacuum tube can be completed after the demolition.
When removing the available detergent or washing powder soaked in water to lubricate the vacuum tube, and the vacuum tube angle should be sent along, avoid cross angle shenglayingche to prevent the vacuum tube burst and wounding, turning around and slowly to push, then the vacuum tube to the other end of the spring come, in the vacuum tube can be gently pulled out from the water tank.
1 first get the waterproof ring down2 then hold the middle of the vacuum tube, while rotating the vacuum tube to the tank, until the sharp part of the bottom of the vacuum tube can be taken out from the solar base3 finally put the vacuum tube into the water from the water tank out of the OK.

Share to: