How to repair cable pliers?
The 8 copper wires of the network cable need not be exposed. The length of 1.5-2 cm is enough. It is convenient for the copper wire to reach the front of the crystal head, and the plastic skin of the net cable can be stuck at the bottom of the crystal head. When you press the crystal head, see if the 8 copper wires are against the top of the crystal head. After pressing, look at the side of the crystal head, the copper sheet on the side of the crystal head (take a used crystal head, the side can be seen with the teeth like copper) embedded into the copper wire, even if it is done.
Knock on the head of the wire clip. If it doesn't work, buy it.
Network pliers, maintenance tools, set of crystal head, line pressure pliers, wire measuring device, wire pliers quality points:(1), handle gap should be small, cut the line to the flush, inferior thin steel plate gap is large, when the upper and lower torsion deformation tangent tangent, partial slip cutting still easy to hurt hands.(2) the cutting of the cutting edge must be even, and it must be treated with heat, and the hardness is up to standard, so that it can be durable.
1, the cable clamp head knock, and if not engage in, then suggest to buy a again, want to buy.
