How to set up Adams gear pair?If you want to do the simulation of the starting mechanism, the wire rope can not be used, instead of using the thin stem instead of the pulley to do the gear rack matching, why do you always make a wrong presentation when you create the gear pair?The, CV, marker,.Model_1.ground.MARKER_35, is, not, on, the, same, part (.Model_1.ground), as, theJ, markers, of, the, joints, for, the, gear,.Model_1.GEAR_1.The steel rope and the earth do slide pairs, the pulley and the earth do the rotation pair
4, the creation of gear pairs, in the pop-up dialog box, Joint Name fill in rotating vice A, mobile vice B; Common Velocity Marker fill in Marker C.6, point OK. gear rack transmission relationship should be able to establish successfullyImportant: the rotating pair A, the Second Part of the moving pair B, and the gear constant velocity point (node) Marker must be of the same component
1. The gear is connected with the frame by the rotating vice A, and the First Part must be the gear2. The rack is connected with the frame by moving pair B, and the First Part must be rack3, on the rack to create a Marker (Marker C), located in the rack and pinion meshing node, and its z axis parallel to the node speed direction (important: the marker must be on the rack)
This error indicates that the condition of setting up the gear pair has not been metFollow these steps carefully to create success:Determine the 3 components that create the gear pair: gears, racks, and racks (the frame can be earth or other components)
