How to simulate motion of a pair of gears in ug8.0

Answer:

3. Create the connecting rod, select the gear drawn in step 1, and create the connecting rod 1 and the connecting rod 2;

2, from the beginning of the NX modeling, enter the NX motion simulation module, and then build a new simulation moving parts;

UG8.0 simulation of the gear movement, in addition to increasing the connecting rod and moving pairs, but also to increase the gear pair, its creation steps as follows:1. First, build two gear parts as shown in the diagram. (about the parameters of the gear design, you can refer to some books on mechanical drawing)

4, increase the motion pair, because the gear is rotating, it is necessary to create two rotating pairs;