Camera film paste: 1, First make sure your screen and screen protector film is smooth, sometimes when mirror got stained with dirt, it will drum up small bubbles; 2 use a little water (oil is also ok, as long as it is dust-free) , to wipe evenly on the film screen (not too much, just a little bit is enough, spilled water or oil is forbidden; 3 then carefully put an end of screen protector film gently affixed at one end of screen, pay attention to push air out (but in general, air bubbles can be avoided in the first place);
1. First opened 1 protective film and throw it away. 2. split LCD facing the camera , aligned with a first side, preferably the long side. If dealing with the shorter side, shorter, it will deviate too much. Slowly post. 3. and then tear up the 2 protective film after last step, throw it away and use it directly. I do not know what to do before, and I just skipped the instruction, and didn't tear 2 up. After one year, I was wondering why the protective film is so easy to be scratched. Later the edge was off, and then I decided to tear it up and buy a new one as its size. I did not expect that when I tore it up, there is another layer of extremely bright film.
Firstly : First, put the purchased lectrostatic sticker on a digital?camera, stretch out the frame of the digital?camera on a screen protector with a marker, you must be very careful while drawing the outline, making sure the size of screen protector you stretched and the screen of digital?camera is identical. Step two: Then start on cutting after stretching, the tool for cutting should be sharp enough like hair scissor, because it is very sharp and very handy to use, and the effect is very neat. All parts require careful trimming. Step three: After cutting, check again the corners of the film, to see if it is entirely appropriate. Step four: And then compare it with the digital camera display, after the inspection is completed, use the auxiliary film to tear down screen protector, then wipe clean the screen of a digital camera, it is best to use deerskin so that digital camera screen won't be scratched. Step five: You must be very carefully while pasting the screen protector. Make it slow to make the protective film bonded to the LED display of digital camera till the inner layer of the film is totally torn down. Then after attaching the protective film to the screen, tear down the outer protective?film.
