How to use a loader to rebuild a roller and use an old 50F loader to rebuild a roller, would like to see the special view
I just put forward a possible solution, not a mature one. As for the vibration, please refer to the 16 ton single steel vibratory roller, you can know what I say, the final use may be only the engine, the back bridge and the cab, fuel tank, etc..
I said change to static rolling, that is, the front part of the loader, such as large arm, are removed, not only leaving the front frame, and then in front of the frame on the basis of the installation of a pressure applied steel wheel program. It has never been implemented, nor has it been implemented.
If you want to change into a single steel wheel compactor, there may be hope, but the compaction capacity will be insufficient. If you change the vibratory roller, the rear frame will move more, and the life expectancy is also difficult to say. The final engines may be the engine, the rear axle, the cab, the tank, and so on.
