It can be cut up at a place where has a shear line, but there is a small piece which is can not be energized, and it is not safe. Clip must be used on one of the ends of the wire and then connect the wire, wrap with daub and black rubber in case of electric leakage, and on another end of the wire should be wrapped with professional daub and black rubber in case of electric leakage. It is about 200 watts per square meter. normal voltage of 220 volts is enough.
1. first, electrothermal?film should set reasonable temperatures. 2. The required voltage of electrothermal?film is 220V, the electricity consumption must be ensured to meet the requirements of electrothermal?film and the security of external power. (low voltage, decreased heating speed) 3. do not use force to impale or strike the surface that is paved with electrothermal?film; 4. the surface temperature of the electrothermal film should be less than 60 degrees, if the temperature is too high, the temperature should be lowered to prevent empyrosis. 5. the electrothermal?film can not be soaked in water, water on the ground should be cleaned in time, if the electrothermal?film is soaked in water, please stop using immediately, and contact professionals to detect. 6. the heating equipment cannot be added on the ground surface which is paved with electrothermal?film equipments. If there is additional equipments, technicists are need. 7. Thermal insulation materials can not be paved in a large area on the ground surface which is paved with electrothermal?film equipments, such as: Foam blankets, yoga mats, quilts, carpets that is more than 3mm in terms of thickness, etc. The ground should be ensured of a good heat dissipation environment. 8. the electrothermal?film heating equipments should be closed if there is nobody besides them.
If the temperature controller and capacitance of it are the same, it can be used, there is no need to find it anymore for it may stops production.
Clip must be used on one of the ends of the wire and then connect the wire, wrap with daub and black rubber in case of electric leakage, and on another end of the wire should be wrapped with professional daub and black rubber in case of electric leakage. It is about 200 watts per square meter.
It can be cut up at a place where has a shear line, but there is a small piece which is can not be energized, and it is not safe. Clip must be used on one of the ends of the wire and then connect the wire, wrap with daub and black rubber in case of electric leakage, and on another end of the wire should be wrapped with professional daub and black rubber in case of electric leakage. It is about 200 watts per square meter. normal voltage of 220 volts is enough.
