How to use the boiler to open a few files

How to use the boiler to open a few files

How to use the boiler to open a few files...

To warm the boiler to 2-3 files can be. To the use of the boiler: 1, the pressure in the use of the boiler should not be set too high in use, the pressure of the boiler must not be set too high, usually maintained at 1.2-1.5MPa is the right, if the pressure is too large, It will damage the life of the sealing parts, when the pressure is too small will occur the system can not run the normal work, adjust the pressure inside the boiler, as long as the open through the leak valve, the water, in the water on it. 2, do not mix hot water and cold water in daily life, the majority of users are often hot water mixed with cold water use, which is no problem in the water heater, but if the use of warm to the boiler will cause some bad consequences , This is mainly because the warm water boiler is not a direct heating, and only after adding cold water will lead to the cycle to change the pressure inside the system, the boiler sensor will often re-set the system heating mode function, Will cause the boiler to re-use, this will accelerate the aging rate of the boiler. 3, the boiler cleaning and maintenance problems At the end of the day, usually we need to warm the maintenance will be cleaned, the user can operate the first switch into the water, and then increase the pressure to 2, open the drain valve, dirty The water will automatically flow out, so repeatedly operation again and again, until the outflow of water is clean on it, and finally should also open the inlet valve and drain valve, after rinsing, clean, must To add clean water, then adjust the pressure to 1.2-1.5MPa on it.