How to use the pneumatic components to control the automatic reciprocating movement of the cylinder (without electricity, mechanical touch control)?
A crank motor connecting rod slider mechanism is driven by a pneumatic motor (a rotating cylinder). Or with a two-way pilot air control valve to design a loop to control the cylinder cycle. The two position five way two-way control valve and the cylinder block are connected into a whole, and the double headed cylinder rod is fixed and fixed, and the trigger positions of both sides of the valve are adjusted, and after the ventilation, the cylinder drives the reversing valve to move back and forth.
It is better to use a steam turbine to drive a structure similar to a cylinder, just like a crank link mechanism in an automobile engine, so that it can be converted into a straight reciprocating motion under the steam turbine.
Usually through the circuit board /PLC control solenoid valve channel switch to achieve reciprocating movement of the cylinder, or with stroke switch to control; if you want to achieve reciprocating movement,
