Instructions: 1. The transfer film products are suitable for the latex?painted wall and other smooth, clean surface. 2. please carefully transfer the film joint pattern from the end of paper peeled off. 3. choosing the location to paste, using scratch cards to hang around to smooth out air bubbles between wall stickers and wall. 4. Remove the transfer membrane, gently tear the membrane and readjust the membrane if it is pushed and runned.
The following is the answer for the question how to use the wall poster transfer membrane inquire tearing down directly and pasted it. instant paste is also called self-adhesion label material, it is a composite material which use the paper and the membrane or special material as the surface material, the back coated with the adhesive and the silicon coated as the protective paper as the bottom paper. instant paste is also called self-adhesion label material, it is a composite material which use the paper and the membrane or special material as the surface material, the back coated with the adhesive and the silicon coated as the protective paper as the bottom paper. Due to there are a variety of coating techniques, resulting in sticky material formed with different grades, the current direction of development from the traditional roll coating, blade coating to the high pressure casting coating direction development in order to ensure maximum uniform coating sensual, avoid generating bubbles and pinholes, coating quality assurance,
Paste 1. Before you begin, make ready tools: Scissors, knives, card, or bank card. First, use the scissor to cut the blank part of the picture surroundings, and it is easy to paste; 2. the transfer film attached to the pattern, and card or bank card scraping back and forth repeatedly on the transfer film several times, so that pattern transfer film more good stick together, there will be no air bubbles attached after the wall; 3. remove the membrane which stick the picture from the bottom paper. if the picture is not pasted in the membrane, you can use the knife to cut it. When attached to a relatively large area pattern, the pattern may be turned to the back of paper and torn from a membrane and the picture; before going to the step 4, the first transfer film cut scrap pick a corner wall test wall performance, make sure the wall having no problem and then paste it. if the wall surface can be dropped powder or when tearing the membrane the wall paint may also be dropped down, please paste it after treatment; 4 texture case when the transfer film can first corner of the first stick to the wall then slowly slow will stick with transfer film along the downward direction of the pattern on the wall, followed by a card from the middle of the pattern repeated strokes of direction around, so better stick wall stickers on the wall; 5 transfer film time to tear away from the wall, try slower, you can while pressing the pattern transfer film tear off one side, the pattern must not be torn up together. Reminder: if you afraid it can't tear down after pasting, you can have a sticker affixed in place with hot water (40-50 degrees) or heating with a hair dryer blowing and tear, it is OK, if you fear to tear down with the glass as well as plastic (available heat water, alcohol, gasoline, kerosene) the stuff can be cleaned.
