Huaxing CNC lathe 41 drive alarm how to solve?
Look at your Z-axis load is not very heavy (with a wrench to the screw, is the state of the shutdown, the table turned on, turn to the knife), if the turn up a little effort, then that is the Z-axis
First disconnect the power, the rear of the electrical cabinet in the Z-axis drive that switch off more than 5 minutes, then boot.
(Multi-use and processing of the emergence of the alarm, such as: the process of sudden alarm, or done a product, the next product on the alarm)
That day my time is coming, so there is not finished, that is, in addition to the above, that is, the drive itself is broken, the bad position is probably the power pulse part (drive inside the pulse power section, there is a large capacitor and inductance
