I want to do a mosaic (broken china) table top, any help on how to grout and how to trim table round edge?
If I were doing this, I would tackle it one of two ways: either place the broken china pieces right on the edge, or, create a rim using a long strip of aluminim (or some other stiff but bendable material) and wrap this around the edge of the table being careful to keep it levelThen, use quickset to place the mozaic pieces where you want themOnce you have completely covered the table (and the pieces have had a chance to set), mix your grout a little on the runny side (not too much though), and splotch it in the middle of the tableUse a squeegy to make sure the grout fills in all the cracksDon't be afraid to go over the edge a bit to make sure of total fillageAfter this has set a bit, use a damp cloth or sponge to wipe off the excess on top of the china piecesWhen the quickset and grout have set, remove the aluminum stripYou can use 150 grit sandpaper (or coarser) to smooth out any rough spotsYou may want to consider a grout sealer to protect the table from spills, etcGood Luck~
