I want to use the motor control card and the servo motor. How do I wire?
In general, the OC output, which is white, is the C pole of a triode, and the circuit of the actuator loop on the servo is ok
The control card is extended on the computer motherboard, and then the computer connects to the driver via the USB cable, which connects to the servo motor through a cable. Then add other power cords and so on. Control the movement of servo motor through motion control software
This is a good link, and the driver has a special interface that is used to swap with the motion control card, such as interface X4. Switching signal is sent CARDS to drive pulse signal and the direction of the pulse signal, then there is the drive send card encoder feedback signal, then there is some what photoelectric switch, such as servo enabled models or SVR - on the ALM, alarm signal, 24 v is the cathode of an external power supply, etc., these signals can interface and the corresponding to the up... Look at the manual of the drive to find the corresponding interface and the corresponding signal lead link... CALL me again if you have any questions
