I would like to ask, aluminum water poured into the mold, what should pay attention to? Aluminum solidification in the mold after the aluminum ingot, how can I get it out?
One side of the mold is generally provided with a push plate, and the two modules are connected by hinges, and the other end is provided with a clip to prevent the aluminum water from expanding into the cavity.
When the mould is opened, the hammer is used to mark the template, and the 4 shafts on it strike another template to make it open. Die casting equipment is generally equipped with a die, directly push the sub templates, mold opening.
Cast aluminium is divided into casting and die casting. In general, mold parting agent shall be applied in the mold cavity.
