TH-110 ice maker adjusts the thickness of ice cubes. "And why does the ice making mechanism stop flowing after a piece of ice?" "it's difficult to push ice out when you have a good piece of ice."
In use, there will be refrigeration ice, but not out of ice, this is because: measuring water temperature probe failure, so that intelligent control system can not effectively perceive the water temperature and work, miscarriage of justice, procedures, errors, or controller failure. The multimeter is used to measure the temperature of the resistance probe (the water temperature in the water tank near 0 degrees C, remove the control box of the three core lines, two lines on both sides of the resistance test), such as resistance in more than 27K, it was judged as controller bad, should be replaced, such as resistance of less than 27K, it shall be disconnect any two lines in a way, through the series resistance of the resistance to 27K to 28K. In use, sometimes ice machine, the machine into the ice removal program (water pump stops working, compressor stop cooling), but ice does not fall off; that is two way solenoid valve damage. Replace the solenoid valve or external loop.
If the ice compressor compressor has a job, but the pump has not work, no running water, that is, pump damage or fouling inside the pump plugThen clean up the pump or replace the pump
May be because the pipeline is no water or water, solenoid valve failure, the valve does not open. First check the water inlet pipe, the water is opened after the water re start
