Home > categories > Home Appliances > Ice Makers > Ice maker is too waste of water, what should I do?
Question:

Ice maker is too waste of water, what should I do?

He bought a 500 pound ice maker, but it's a waste of water, a few tons a day. How can you make use of the water? Washing the toilet and washing the floor can't take a few tons a day, so don't say anything about it. How can we reuse this water to drink? The water that flows out is also at normal temperature

Answer:

If you use less than 500 pounds of ice, how can you buy such a big one? See how much ice you use to stop ice making. That's the root
The pump can be used to raise goldfish with an ordinary pump, the head of about 5 meters, as far as possible to use high-power pumps, or other pumps;Of course, if necessary, a strainer can be installed in the high barrel to ensure that the cooling water flowing into the ice making machine has no granular material;After doing so, the average daily consumption of water locks can be ignored, but only once a week need to add water, probably a few kilograms of it.
The aim is to reduce the temperature of the water by circulating the heat of the circulating water into the air;3. Install a (high) water level control switch (stroke switch) in the high barrel. When the water level in the upper barrel reaches the upper limit, the control switch sends out the limit command or signal;4, in the lower barrel also installed a control switch, when the low bucket of water is about to fill, that is issued a control signal;5 、 use two electronic controller (also can use a duplex controller) to control the water pump of lifting water level together;
1. Make two big water storage buckets, one position higher than ice maker, the other one lower than ice maker;In this way, if there is water in a high storage bucket (hereinafter referred to as "high barrel"), it will automatically flow to the lower storage tank by the ice maker (hereinafter referred to as "low barrel");2, in the high barrel and low barrel, each configuration of an air-cooled radiator, shape similar to the CPU radiator, but the volume as much as possible;

Share to:

Hot Tag