Im looking for the water flow rate thru 1/2 inch copper pipe?
shirts can be used as rags
Water piping is sized for the call for and available tension. in case you have a 6 bathing room monster living house a nil.5-mile faraway from the line, one million may well be rather lite. in case you have a particularly 'known' living house with known water tension, it particularly is in all likelihood fantastic. i've got on no account run something smaller than one million right into a house. 3/4 may well be ok each now and then, however the value distinction in supplies is negligible and the exertions is relating to an identical. i would not attempt to repair a galvanized water provider. it particularly is have been given to be in the community of fifty years old. it particularly is finished. in case you fix the leak, you will likely purely get yet another one quickly. and take a glance interior the old galvanized whilst it has bumped off. it particularly is specific to be clogged with 50 years of rust.
Aplly the following formula: G w * A, where: G - flow rate [m^3/s] w - speed of fluid [m/s] A - transversal section area of the pipe [m^2]
honestly, if u use ur clothes so much that they get ripped up and are horrible, i'd just use them as rags. from now on, u should stop using them so much and give them to the homeless before that happens. don't insult them with ripped clothes.
1/2 diameter pipe has an area of 0.0013635 ft^2 60 psi roughly equals a velocity of 88.125 fps (feet per second) using the equation Q (flow) V (velocity) * A (area) we get a flow rate of 0.12016 cfs (cubic feet per second). Now you can convert that to whatever units you are looking for.
