Installation and debugging of insulating glass processing equipment
(7) clean the water tank before watering the tank.(8) after installation and adjustment, test in accordance with the order of operation as specified in this specification.(9) clean the minimum size glass, do not place parallel with the roll.
(3) adjust the support, adjust the level of the whole machine, tolerance 1.5MM, longitudinal 3MM (only the feeding section is higher than the discharge section).(4) after the longitudinal levelness of the machine meets the requirements, the four sections of the frame are connected and fastened (the frame is provided with a connecting bolt pair).(5) in the feed section, the frame and the cleaning section, the frame, the cleaning section, the frame and the drying section, between the frame, is coated with the glass glue, in order to prevent two leaks.(6) connect the transmission systems according to the relevant standards.
(1) site conditions shall include 380V AC power supply, industrial source water supply and drainage ditch. Most of the insulating glass equipment and door and window equipment are 380V, mainly in order to maintain the stability of equipment work. Clean unsolicited water supplies, as well as unblocked drainage, are the guarantee for the good work of the cleaning machine.(2) correctly place the feeding section, the frame, the cleaning section, the frame, the drying section, the frame, the discharging section, the frame, the control cabinet and the ventilation case. If not placed in order, will reduce work efficiency, two will not pass the product quality.
