Installation points of glass fiber reinforced daylight tile
? when the light tile and the steel plate overlap vertically, 200mm overlap must be minimum and two water hoses are attached.- lighting tile fixed, must use good water washer between the screw and the plate between the lighting, in order to waterproof and dustproof.
Later, laid aside, plate location, construction by gradually to the direction of the roof eaves. The light plate is directly buckled on the side crest of the steel plate.? daylighting tile in front of the fixed pilot hole, the aperture must be greater than the diameter of the fixed screw 6-9mm, as the expansion and contraction.
The flashing gasket set into the screw, drill into the lock to complete work purlin, fixed lighting board.Daylighting tile construction, strictly prohibit feet directly on the crest, so as not to light plate cracking. Must be placed in the horizontal position of the lighting board, a piece of 1200mmx300mm{long, x width) anti-skid thick board, foot on it in the lighting board guide hole and fixed screw work.
