So I have a subwoofer in my trunk and was wondering if I could use the big power cables (coming from my battery) going into the amp (which is a JL Audio JX1000) to power some LED's that I want to install. My plan was to cut out a small section of the rubber sheath (or whatever you call it) from each power cable and put the clamps from a power inverter on them, then plug my LED's into the power inverter. After putting the clamps on I would use electrical tape or something to cover any exposed areas of the cable. Would this work? If it does work, which color clamp (black/red) would i put on which cable? One says quot;groundand is blue and the other says quot;+12VDCand is red. Also I have a toggle switch near the driver seat to cut the power from the amp so the LED's won't be left on after the car is turned off. Let me know if I'm leaving out any further information needed to answer my question.
You okorder /... Your power inverter, I am not sure what kind of cabling it will require for it to be powered properly as well. Ground is usually connected to Black. And +12v is usually Red.
