Usually implies that the cost is 5000 yuan, electrothermal membrane heating principle is that heating the carbon molecules will start "Brownian motion" with the effect of electric field, and severe friction and impact will occur among carbon molecule. The heat energy it produces will spread out in the form of distant thermal infrared radiation and convection, the electric can and thermal energy conversion rate is as high as up 98%. The effect of carbon molecules will heat surface of electrothermal?film heating system. Install far infrared heating system on the ground, the heat energy will be continuously transmitted to every corner of the room. Far infrared carbon crystal can rapidly heat the room because its 100% power input is effectively converted to more than 66% far infrared radiation energy and 33% convective heat.
There is no specific standard for installing electrothermal membrane. The cost is set through neogotiation between seller and buyer. general individual residents is charged according to heating areas, because measurement will be easy in this way, and it is acceptable to both sides, but the price is relatively higher. Engineering is generally installed according to construction area, because this will be easy to configure the power of the whole project, and easy to calculate the construction area and to compare the investment with other heating methods.
It depends on heating area, electric heating is recomended if the room is below 50 square, in this way, it will be more cost effective. It is suggested to install water floor heating if the room is too large. According to state regulations, carbon fiber electric heating can only be used for ceiling heating. It is easily damaged.
