Is it possible to manually weld LED bulb bulbs?
This is what you do very mature products, the most simple aging, is like this
As long as the welding technology clearance is possible or OK
Well, the lights go straight up, aging, usually 24 hours of aging, testing, you have to open 10 seconds, 10 seconds off, so non-stop switching for 2 to 4 hours
If you can guarantee that you can add thermal grease just fill the gap without obstructing the normal contact, it is useful, but this process is very difficult for you to do, and the theory can improve the thermal efficiency of thermal grease, but actually you are not up to the process it is possible to reduce the thermal efficiency, you added more is to seek psychological comfort, you can on the heating plate welding of light, with one side of the thermal grease solder, such thermal effect is better
You can ignore the effect of heat conduction and thermal grease, solder is better, I was doing a lot of tests, the thermal conductivity of thermal grease is about 1.2 to 2, aluminum more than 300, thermal grease just to fill the bottom of the LED and the aluminum substrate contact surface gap, you don't fill gaps don't hinder it the normal contact with the aluminum substrate at the bottom of the LED, will be lost, and the use of thermal grease you for about a year will have to replace the thermal grease, only unscrupulous vendors will deceive others say I added thermal grease, heat conduction effect is not fully qualified, in fact, for a long time, the potential will LED light spot the chip inside the loose because of the long-term high temperature, causing the current growing, until completely off
