Is the ice making mechanism not affected by the environmental temperature?
(a minute after the ice machine did not start) power supply external power supply electric air switch trip please check whether the power provided by the user to check whether is normal according to equipment requirements configuration power switch failure replacement switch button emergency stop switch is closed to the right. Let the switch reset control power switch off the power supply to replace P00 tube burning insurance insurance PLC no signal input signal power press the green button when the input signal PLC P01 no signal input
Common faults and troubleshooting of the ice machine (20 PLC) fault processing method of ice making machine operation press the switch button, reducer start, 30 seconds after the start of the compressor
Press the switch button to run the ice machine, speed reducer start, 30 seconds after the compressor start. (one minute after the ice machine did not start)The external power supply is without electricityCheck if power is offAir switch tripPlease check that the supplied power is normalDo you configure the power switch according to the equipment requirements?Start switch failureReplace the switch buttonThe emergency stop switch is offTurn right to reset the switchThe drain of the control power supply is burned outTurn off the power and replace the pipePLC P00 point, no signal inputpower signalWhen you press the green button, there is a signal inputPLC P01 point, no signal inputShutdown signalThere is a signal input when pressing the red buttonPLC P02 point, no signal inputCompressor overload, protection module failureCheck the running current of the compressor and the current setting value of the heat protector and reset button. Please contact us if the protection module is out of orderPLC P03 point, no signal inputReducer overloadCheck the running current of the reducer, the current setting value of the heat protector and the reset key. Check whether the water pump and the reducer are connected to the groundPLC P04 point, no signal input
Condenser motor overloadCheck the running current of the condenser motor, the current setting value of the heat protector and the reset key. Check whether the water pump and the reducer are connected to the groundPLC P05 point, no signal inputPump overloadCheck the running current of the pump motor, the current setting value of the heat protector and the reset button. Check whether the water pump and the reducer are connected to the groundPLC P06 point, no signal inputCompressor high voltage faultCheck condenser fan and condenserPLC P07 point, no signal inputCompressor low voltage faultCheck whether the water inside the ice bucket is normal, ice fall is normalCheck that the system has leaksPLC P08 point, no signal inputFailure of water supply systemCheck whether the water supply system is working properly, whether the water in the water tank is adequate, check whether the water level switch is good, or replace
