I'v had 5 people at school say steel is stonger than Titanium and some(5) kids at school say titanium stronger then steel but i looked it up on the internet and i got soem web sites that say steel is stronger then titanium and some sites that say titanium is stonger then steel sooooo???? witch one is strongerPS i no tungsten is stronger then steel.... and titanium.................
This Site Might Help You. RE: is Titanium Stronger than steel? I'v had 5 people at school say steel is stonger than Titanium and some(5) kids at school say titanium stronger then steel but i looked it up on the internet and i got soem web sites that say steel is stronger then titanium and some sites that say titanium is stonger then steel sooooo?? witch...
Titanium has better high temperature strength than steel. Titanium doesn't resist shocks like steel can. It's more brittle. It's also far more difficult to weld. Titanium must be welded in an oxygenless environment. The average strength of steels that are made is under that of titanium. However, the strongest steel is stronger than the strongest titanium. Steel is the only viable building material. Titanium is too rare, expensive, and hard to handle for structures of great height. Hope this helps. Peace and Love.
TITANIUM is stronger than STEEL. For steel:(I am taking high tensile steel)- Material Yield strength(MPa) -1650 Ultimate strength-(MPa) -1860 density(g/cm3)- 7.8 For Titanium:(Titanium is as strong as steel, but 45% lighter) Tensile Strength : 460-615 N/mm2 So, stregth to weight ratio is higher for titaneum. Titanium is as strong as steel but much less dense. It is therefore important as an alloying agent with many metals including aluminium, molybdenum and iron. These alloys are principally used in aircraft and missiles as they are materials which have low density yet can withstand extremes of temperature. Titanium also has potential use in desalination plants which convert sea water to fresh water. The metal has excellent resistance to sea water, and so is used to protect the hulls of ships, and other structures exposed to sea water. However, the largest use of titanium is in the form of titanium(IV) oxide, which is extensively used in both house paint and artists’ paint. This paint is also a good reflector of infrared radiation and so is used in solar observatories where heat causes poor visibility. please read below:;;; The tensile strength of a material is the maximum amount of tensile stress that it can be subjected to before failure. The definition of failure can vary according to material type and design methodology. This is an important concept in engineering, especially in the fields of material science, mechanical engineering and structural engineering. There are three typical definitions of tensile strength: Yield strength - The stress a material can withstand without permanent deformation. This is not a sharply defined point. Yield strength is the stress which will cause a permanent deformation of 0.2% of the original dimension. Ultimate strength - The maximum stress a material can withstand. Breaking strength - The stress coordinate on the stress-strain curve at the point of rupture.
