ive got just one bowl to last the rest of the day, wich means i need to make a fat resin ball for later? whats the best way to do that
You should be able to tell in a few minutes by simply putting the starter fluid on a bit of cloth, laying it on the ABS and covering with plastic sheet to keep it from evaporating too quicklyFeeling the surface will tell you if the AVS is softened You need to also consider the risks of ether on you breathing the stuff.
heat it up with a lighter - this will make the resin soft and stick easierthen, take a paperclip and gently cover all nooks and crannieswhen you have some buildup on the paperclip, pull it out and use a sharp knife to collect whats on the paperclipleave it on the knife for now.take you time and be sure to not jeopardize the fragile bowl by pushing or scraping to hardbend the paper clip in direction ways to get those hard to reach spotsafter you have collected all the resin(it should still be on the knife, or collected in a ball), make a small aluminum foil ball and put in the main hole of the bowl.(this is so the resin doesnt go back in the pipe)take a huge hit, hold it in and waittry to concentrate on the buzz, as this will allow you to be content on the high at hand and conserve the resin for the whole daygood luck.
I think you will get better results in the chemistry categoryany weakening of the pipe would be from a reaction with the starter fluid, which would be a chemistry issue I doubt it will hurt it, but I am not an expert on that.
