Laptop power adapter water
Try not to try, an adapter is 100 dollars or so, do not accompany the computer!
Do not use the power adapter water, to prevent the power supply instability burned motherboard, buy directly, the power is not the value of maintenance. The removal method is as follows:
Laptop power adapter for the upper and lower cover for injection molding or bonding with a strong adhesive, without any screws, so generally only with violence to crack. However, as long as the method properly, after the dismantling of the power adapter can be restored to the original, do not carefully observe almost no traces of open.
Place the power adapter on the side of the white paper, cut the gap between the upper and lower covers of the power adapter, and then use the hammer to strike the electric knife back (Figure 1), so that the electric knife from the adapter under the cover between the cut Go in. In the different positions of the gap between the upper and lower covers of the adapter, use the tip of the electric knife to be scratched along the crevice. When the upper and lower covers are first split, the tip is deepened, and then the upper and lower covers of the adapter are slowly separated.
This stuff is generally sealed better, certainly not much water, but the water is not easy to come out. You can not blow the hair blower, inside the water will be left behind to re-condense into water droplets, so the most appropriate way is to high temperature, dry place put a few days to re-use, when the plug after the computer power , Will soon be able to evaporate the remaining water vapor
