Lightweight wallboard light steel keel how to construction
Light ends of the keel should be installed firmly, keel and the base of the fixed point spacing should not be greater than one meter, installed through the series keel, less than three meters of the partition to install a three to five meters installed two When the transverse joints are not on the edge, along the top keel, should be added to the dragon keel fixed, doors and windows or special joints to install additional keel should meet the design requirements of the skeleton wall in the installation of decorative panels should check the firmness of the skeleton , Whether the installation of wall equipment, pipeline and filling materials meet the design requirements If there is a non-compliance should take measures. Light wall panels The installation process as long as the step by step, the order of work also need to be more cautious.
Damp room and steel plate plaster wall, light partition board keel spacing should not be greater than hundreds of millimeters, the installation of supporting keel, the support card should be installed in the direction of the vertical keel opening, partition wall card should be four hundred To six hundred millimeters, from the keel at both ends of the distance should be twenty to twenty five millimeters, should be fixed according to the location of the ball along the edge, along the keel and border keel, keel line should be coincident with the line.
Wood keel installation to keel cross-sectional area and vertical and horizontal spacing should meet the design requirements, lightweight partition plate skeleton horizontal, vertical keel should be used to open half a tenon plus glue, plus nail connection. Before installing the panel, the keel should be fire-treated, the wall should be in accordance with the design requirements, along the ground, the wall top wall and the width of the wall line, the width of the wall should be consistent with the thickness of the wall should be clear, Accurate, the installation of vertical keel should be vertical, keel spacing should meet the design requirements.
