Loading process of longitudinal shearing machine?
Interval take-up: the take-up device is the upper and lower two layers, and in actual operation it can be divided into two layers to receive or place a far end spool. Each insert a good copper undercut a spacer and spacer ring, finally fastening. Each piece should have a certain gap, and cut to the spacer between the copper and the vertical spacer distance appropriate to prevent wire and spacer friction burr; adjusting winding device and unwinding device, so that the tension is appropriate, if the receiving volume elasticity is close together, should relax the point material tension device.
Pressure regulating plate: the width of the assembled platen is wider than that of the cut copper strip, 0.5~1mm, adjusting the left and right side limiting blocks so that the center of the press plate is facing the hob center and locking the left and right block blocks. Try to cut copper cut with scissors cut about 20cm length, according to the material about the situation on both sides of the pressure plate is adjusted, until the meet the requirements so far.
Tool setting: both hands are pressed at the same time, when the upper and lower knives will contact, stop pressing. The axial adjustment of the knife shaft, the bite on the knife blade and the lower knife groove, to prevent the occurrence of eating knife phenomenon; the knife to rotate the hand wheel under pressure, so that the upper and lower knife bite, bite depth to moderate attention. After a good hob, try to cut with a strip of paper, if the paper can be opened smoothly, then tighten the knife, tighten the bolt, if not cut, then continue to knife until you can cut the paper. Lock knife fastening bolts, cut with scissors to cut materials to test their length about 20cm, according to the test cut adjustment tool can cut out a good product, in order to ensure safety.
Installation: wear gloves, first put the knife, the lower knife will be fastened and then put on the knife, when operating, to prevent tool collision.
