Home > categories > Machinery & Equipment > Bending Machinery > Machining - Bending Technology
Question:

Machining - Bending Technology

Machining - Bending Technology

Answer:

Third, the choice of V slot is not the same, the size is not the same expansion, if it is commonly used slot width
Beautiful words, of course, the smaller the better the R angle, but there is a problem, the use of small V groove, then you must consider the pressure of the bending machine, too small V groove is not folded 90 degrees, and indentation is also deep;
First, the material did not indicate, if the material is SPCC that type, the thickness is 5mm, the commonly used slot width is 25V;
First, the material did not indicate, if the material is SPCC that type, the thickness is 5mm, the commonly used slot width is 25V;

Share to: