Machining center 8 mm carbide cutter processing 45 steel, how to set the speed, feed, and moving speed?
Faster, two RPM 1 mm, too fast, with G96 RPM feed 0.2 below
if the speed in the three thousand, each Z axis 0.3 wire feed, can be a little faster, must spiral knife Oh, this is not a knife eat 5 mm. I found a 55 degree flat cutting parameters of tungsten steel milling table
You should be a 8 mm tungsten steel milling cutter, the speed should be controlled below 2200 to 3000, because the speed and your cutting are related to the amount of advice:
