Machining center with an end mill milling side of the surface when the collapse is caused by what causes.
End Milling Cutter The end mills are mostly clamped by spring clamps and are in cantilever state when used. Milling process, sometimes the end mill may appear from the tool holder gradually extended, or even completely fall, resulting in scrap phenomenon,
Machining center with the end mill milling side of the surface should be a shock pattern, the main may be too long tool clamping length, or processing margin is too large, or the accuracy of the tool or spindle, when using the end mill Note the following:
the knife hole will be attached to a layer of misty film, when the knife knife folder are deposited on the film, Difficult to firmly grip the handle, the processing end mill is easy to loose drop. So the end mill before clamping, should first end knife handle knife hole with cleaning fluid cleaning,
the reason is generally because the knife hole and the end of the cutter between the outer diameter of the oil film, Lack of force caused by. Milling cutter factory is usually coated with anti-rust oil, if the use of non-water-soluble cutting oil cutting
