Emergency cut off the power after the computer can not open the machine, an open is a lot of words there are seconds limit, you can choose to be able to choose a click on the boot, but the point also repeat that, I would like to ask how to do it? More
MSA BigBangMarshall (B3) 8 PCI-E slots, support your second generation cpu main chipset: IntelP67CPU slot: LGA1155 memory type: DDR3 integrated chip: sound card / network card display chip: no motherboard board type: XL-ATX plate type USB interface: 8 × USB3.0 interface SATA interface: 4 × SATAII interface; 4 × SATAIII ... power supply mode: 24-phase network card chip: onboard RealtekRTL8111E dual Gigabit network card ... audio chip: integrated RealtekALC8928 channel sound Core ... CPU Description: Support IntelSandyBridge processor standard accessories after-sales service MSI BigBangMarshall (B3) detailed parameters to switch to the traditional form of motherboard chipset integrated chip: sound card / network card chip manufacturers: Intel main chipset: IntelP67 chipset Description: Chipset Display Chip: No Audio Chip: Integrated RealtekALC8928 Channel Audio Chip Chip Chip: Onboard RealtekRTL8111E Dual Gigabit Network Card Processor Specifications CPU Platform: Intel CPU Socket: LGA1155CPU Description: Support IntelSandyBridge Processor Support CPU Quantity: 1 Memory Specification Memory type: DDR3 memory slot: 4 × DDR3DIMM maximum memory capacity: 32GB memory Description: support dual-channel DDR ( (OC) / 1333 / 1066MHz memory expansion slot PCI-E slot: 8 × PCI-EX16 graphics slot mining rely on graphics cards. You say MSI Z77A-GD65GAMING not only, but more than the slot, but only three 16X, those 1X is not inserted with the card, you plug in the transmission speed is slow to die, but also dig what mine
Shop copper before you estimate the area of the blank location, but also consider whether the need for grid cells. If the area is large, it can be set, such as 0.5 * 0.5MM; if the area in general, you can "grid" set some of the fine, such as the size of the grid, if the area is not large, 0.3 * 0.3MM. 0.508 grid, 0.2032 line width, out of the "grid" about 0.3MM. Others and so on. If you estimate the shop after the copper is not large, do not want grid hole, then you will line width and grid set from the same, there is no grid hole.
