Method for assembling oak dressing table
Install the other connecting board in the same way as above.5. then the mirror from the plane straight up, put on the countertop near the connecting plate, gently move back and forth so that the upper end of the connecting plate is hole and mirror back holes respectively correspond to keep balance and fall down carefully dressing mirror.
The dressing table and the dressing mirror are disassembled and assembled. We usually use the connecting plate and the flat head screw connection method.First, get ready"Ten" shaped screwdriver one, the specific steps are as followsA cutting part of a connecting board is clamped into the back panel of the dressing table, so that the lower end holes are respectively aligned with the corresponding holes at the back of the dressing table and are kept flat, and then the flat head screws are inserted into the hole of the connecting plate"Ten" type screwdriver, tighten the screw head clockwise, and counter clockwise.Install the other connecting board in the same way as above.Then the mirror from the plane straight up, put on the countertop near the connecting plate, gently move back and forth so that the upper end of the connecting plate is hole and mirror back holes respectively correspond to keep balance and fall down carefully dressing mirror.Finally, screw the flat headed screws into the upper hole of the connecting plate"Ten" type screwdriver, tighten the screw head clockwise, and counter clockwise.When splitting the product, the flat head screws and the connecting plate must be removed and installed when assembled.
Finally, screw the flat headed screws into the upper hole of the connecting plate, tighten the flat headed screws in clockwise direction with "ten" shaped screwdriver, and counter clockwise.
1. the dressing table and the dressing mirror are assembled and disassembled. We usually use the connecting plate and the flat head screw connection method.2., first of all, prepare a "ten" shaped screwdriver, and the specific steps are as follows:3. a connecting plate cutting part of the card into the dresser at the lower end of the back panel parts, holes are respectively aligned dresser back corresponding holes, flat remain motionless, and then into the flat screw plate, clockwise to tighten the pan head screws with "ten" screwdriver, counterclockwise direction resolution.
