Method for connecting cable between street lamp and street lamp
Construction is generally in accordance with the map. If there is no picture, we often use: 1, a cable, in the location of the lamp to build a manual well, with T-shaped connection method, and then lead wire to the inside of the lamp line. 2, the cable from the base through the wire hole into the lamp post, cut off the required two or more lines, respectively, with the wiring nose pressed the same color line, then the insurance into the line end.
Is now widely used in the whole cable wear, probably set aside from not less than 700mm, and will open in the middle, take a zero, a fire, a head, throw to the power on the street where. Pay attention to three-phase matching.This is safer and increases the installation speed considerably. It takes time to make a cable head.
Better keep. A breakpoint is produced. First, the operation cost increases, the middle head is needed, and the two is the maintenance cost increase. A breakpoint is a maintenance point.
