Method for using small-sized edge banding machine
What type of edge banding machine?
NB7C? What about that one? The south is 60C. or 60CY at the beginning of the hindu.
1. Turn on the power before checking whether the switch is in the closed position. Close the trimming and turn the heating switch on the right to make it work.2, the edge belt is arranged on the rotating disc edge is greater than the thickness of 3-4MM, otherwise edgeband can not completely seal plate, there will be a period of above or below the seams phenomenon, the edge by hand pressure with five-star lever into the scissors seat, front and rear belt pressing lever presses down edgeband not too tight, not too loose, too tight edgeband cannot pass through the pressure rod, loose edge will appear in front of or behind the phenomenon of deviation.3, before the start of the work to see if the melt has been melted, and then send the material size of the pressure modulation plate thickness, size, start the transfer switch, check the amount of sizing, and whether it is suitable for working conditions.
