Home > categories > Measurement & Analysis Instruments > Clamp Meters > Methods use a table clamp type table and the matters needing attention
Question:

Methods use a table clamp type table and the matters needing attention

Methods use a table clamp type table and the matters needing attention

Answer:

The measurement in high voltage loop, prohibit the use of lead from the clamp ammeters another meter measurement. When measuring the phase current of high voltage cable, the distance between the cable head and line should be above 300mm, and the insulation is good, which can be carried out when the measurement is convenient.
The observation time, we must pay special attention to keep a safe distance from the head and charged part of the human body and any part of the charged body distance shall not be less than the entire length of the clamp meter.
Clamp current meter high, low two, for without dismantling the current in the circuit fault line under the condition of direct measurement. The following methods: (1) the use of high voltage clamp meter should be paid attention to when the voltage clamp current meter, prohibit the use of low voltage electric current clamp meter high voltage measurement circuit. With high voltage clamp meter measurement, by the two person operation, non duty measurement should fill in second working ticket, should wear gloves when measuring stand on the insulating mat, must not touch the other equipment, to prevent a short circuit or grounding.

Share to: