My satellite TV receiver signal strength of 60%, signal quality 0%, this is how?...
This phenomenon indicates that the connection is correct, the pan direction does not aim at the satellite tuner, or not installed in the focal point of the pot. The solution is..:1 adjust the elevation and horizontal direction of the pot repeatedly.2 adjust the tuner in the center position of the depth of the pot.3 adjust the tuner, the 0 line on the housing nearly parallel to the horizontal plane.Several adjustments aim at achieving the highest signal quality. When the quality of 30%, you can watch, of course, the higher the data, the better the effect of viewing.
but is a relatively cumbersome process of the antenna, see your question should be professional, the most stupid way put the TV in the swinging pan can directly see the place now, slowly a little swing, to put a little bit fixed a few seconds, because the receiver to receive satellite signals need time, some time longer, then left or right turning point, repeat on,
Question: I saw it the other day. Just for a few days. Help, and, 1, the antenna is to offset, the signal strength is representative of the television receiver tuner to signal strength, signal quality is a representative tuner receiving satellite signal quality, if you have this signal quality for 0 words, you are not receiving the satellite signal, you need to adjust the direction of the pot, may is the wind of your home pan blow direction,
