Needle printer does not suck paper. What's the reason?
Third reasons to solve the problem: the sensor is broken, called production home maintenance, general maintenance is not expensive, 100 yuan can be done.
The first reason solution: print on right hand side with a paper control rod, into a single sheet of paper should be put in a single page position, into the continuous paper should be put in the continuous paper position, if the position is not a paper control rod, it may cause cannot feed. It could also be progressive paper, you've done the next paper.
The printer does not take the paper, there are three reasons: one is not switching paper type, a paper is put in the wrong position, there is the bad sensor input (the premise is you not mistaken, you put the rod) of the front lid plastic turned down. You can see the ribbon below where the paper is placed. There is a plastic projection, you press, there will be paper action, if not respond, it is broken. If so, just put the paper in and press it manually.
The second solution: if you're working on the printer's panel, the printer is fed by your right hand side. If the paper position is wrong, it can't be fed. You can try to push the left side of the right move.
