For example, how many sizes and pressures are used in the two piece?
A piece of ball valve is mainly manual, two piece ball valve for atmospheric pressure and high pressure, three pieces of ultra high pressure will be used, according to the actual caliber to determine
A piece of ball valve, the current market pressure of most products below 6.4MPA, two piece ball valve about 12.8MPA products are also common, there are 20MPA, three pieces of ball valves are mostly below 6.4MPA. Know the characteristics and shortcomings of these three kinds of ball valves, you can completely choose according to your own needs.
First of all, the difference between a ball valve and two chip, three chip ball valve is a ball valve flow, the internal structure of the necking design belongs to the design, the same diameter ball valve products must be smaller than the other two kinds of ball valves flow more. Compression capacity is not as good as two, but better than the three chip. A ball valve has the advantages of low cost, low price; the two valve is the three products in the most excellent in resistance and flow, the valve inside is preferred; features three ball valve design structure is easy to install, because the three ball valve can be installed by dismantling during installation, so in different pipeline even some other connections are completely no problem, fast loading, thread, flange, welding and so on, so the market is the most complete connection number of ball valve, especially when welding, a chip ball valve and the two valve can not be opened due to installation, want to welding in the pipeline it would be easy to the inside of the PTFE (similar to plastic) in a burnt out, the best choice at this time is three piece ball valve. But the disadvantage of three piece ball valve is the poor compression ability.
